Product Introduction
1. Used for frame seat tube fatigue test
2. Static test: speed of force "load increase rate, and displacement increase rate",
and holding pressure "position displacement, and Constant load>time can
be set. Can draw curves and store data.
3. Dynamic test: A and B two cylinders are independently controlled [two cylinders
with different test times, frequency, start time, End time, pause, the two
cylinders do not affect each other]. The wave type is a sine wave.
4. The current data is automatically saved when the power is turned off, and the
untested times can be continued after the power is restored.
5. After the dynamic test computer system "A, B two cylinders" pauses or stops the
test, the previous test can be continued Go ahead and test it.
6. Remote test data management and monitoring can be performed, and the test
action will not be affected if conditions permit.
7. The check table is an independent execution file, which will not affect another
cylinder being tested.
8. Report output format: WORD.
9. Real-time display of test peak value: Graphical real-time display "force-time,
displacement-time, force-displacement"
10. The dynamic test computer system "A, B two cylinders" can automatically record
the maximum life curve of force/displacement And a single complete
waveform, you can set the number of times for archiving at intervals. and
a single complete waveform at shutdown.
2. Static test: speed of force "load increase rate, and displacement increase rate",
and holding pressure "position displacement, and Constant load>time can
be set. Can draw curves and store data.
3. Dynamic test: A and B two cylinders are independently controlled [two cylinders
with different test times, frequency, start time, End time, pause, the two
cylinders do not affect each other]. The wave type is a sine wave.
4. The current data is automatically saved when the power is turned off, and the
untested times can be continued after the power is restored.
5. After the dynamic test computer system "A, B two cylinders" pauses or stops the
test, the previous test can be continued Go ahead and test it.
6. Remote test data management and monitoring can be performed, and the test
action will not be affected if conditions permit.
7. The check table is an independent execution file, which will not affect another
cylinder being tested.
8. Report output format: WORD.
9. Real-time display of test peak value: Graphical real-time display "force-time,
displacement-time, force-displacement"
10. The dynamic test computer system "A, B two cylinders" can automatically record
the maximum life curve of force/displacement And a single complete
waveform, you can set the number of times for archiving at intervals. and
a single complete waveform at shutdown.