Product Introduction
1. Servo motor 3 KW .
2. Two load sensors of 1000KG (located under the bottom plate, the source of the force obtained after the
calculation of the trigonometric function and Fourier FFT function is the resistance of the measurement),
and the rod sensor 500KG
3. High strength reducer
4. Three sets of back molds
5. Swing arm Aluminum alloy combination
6. Large computer control cabinet: high-end computer, NI DAQ controller
7. Infrared centering device (H point)
8. The test platform can be raised and lowered to match the adjustment of the H point
9. Power : AC 3Ø, 220 V, 50/60 Hz
10. Countertops 150x100 cm.
2. Two load sensors of 1000KG (located under the bottom plate, the source of the force obtained after the
calculation of the trigonometric function and Fourier FFT function is the resistance of the measurement),
and the rod sensor 500KG
3. High strength reducer
4. Three sets of back molds
5. Swing arm Aluminum alloy combination
6. Large computer control cabinet: high-end computer, NI DAQ controller
7. Infrared centering device (H point)
8. The test platform can be raised and lowered to match the adjustment of the H point
9. Power : AC 3Ø, 220 V, 50/60 Hz
10. Countertops 150x100 cm.
